Gamma ray logging
Issuing time:2019-07-27 00:00
Gamma ray logging is a method of measuring naturally occurring gamma radiation to characterize the rock or sediment in a borehole. It is sometimes used in mineral exploration and water-well drilling, but most commonly for formation evaluation in oil and gas well drilling,Different types of rock emit different amounts and different spectra of natural gamma radiation. In particular, shales usually emit more gamma rays than other sedimentary rocks, such assandstone, gypsum, salt, coal, dolomite, or limestone because radioactive potassium is a common component in their clay content, and because the cation exchange capacity of clay causes them to adsorb uranium and thorium. This difference in radioactivity between shales and sandstones/carbonate rocks allows the gamma tool to distinguish between shales and non-shales.
The gamma ray log, like other types of well logging, is done simply by lowering an instrument down the hole and recording gamma radiation variation with depth. In the United States, the device most commonly records measurements at 1/2-foot intervals. Gamma radiation is usually recorded in API units, a measurement originated by the petroleum industry. Gamma logs are affected by the diameter of the borehole and the properties of the fluid filling the borehole, but because gamma logs are most often used in a qualitative way, corrections are usually not necessary.
Three elements and their decay chains are responsible for the radiation emitted by rock: potassium, thorium and uranium. Shales often contain potassium as part of their clay content, and tend to absorb uranium and thorium as well. A common gamma-ray log records the total radiation, and cannot distinguish between the radioactive elements, while a spectral gamma ray log (see below) can.
For standard GR logs the value measured is calculated from thorium in ppm, Uranium in ppm and potassium in percent. GR API = 8 × Uranium concentration in ppm + 4 × thorium concentration in ppm + potassium concentration in percent. Due to the weight of uranium concentration in the calculation anomalous concentrations of uranium can cause clean sand reservoirs to appear shaley. Spectral Gamma ray is used to provide an individual reading for each element so anomalies in concentration can be found and interpreted.
An advantage of the gamma log over some other types of well logs is that it works through the steel and cement walls of cased boreholes. Although concrete and steel absorb some of the gamma radiation, enough travels through the steel and cement to allow qualitative determinations.
Sometimes non-shales also have elevated levels of gamma radiation. Sandstone can contain uranium mineralization, potassiumfeldspar, clay filling, or rock fragments that cause it to have higher-than usual gamma readings. Coal and dolomite may contain absorbed uranium. Evaporite deposits may contain potassium minerals such as carnallite. When this is the case, spectral gamma ray logging can be done to identify these anomalies.